CNC joint skill builder… no glue just slip lock and load

Posted on by Michael Fuller

FirePlaceToolRack Joint System

FirePlace Tool Rack assembled
the cruciform of the base tree trunk

Cruciform Trunk Base
attached to Chinese Swastika Tree Branches clockwise
attached to Bolt Stems counter clockwise
This allows the cantilever load to be centered over the vertex of the cruciform trunk
1 1/4″ depth Branches/trunk Lap Slotted Joint

Midpoint to Midpoint + 1/4″ bit
Lap Slotted Joint
Detail
Detail
Trunk Slotted Lap Joint Detail
Branch Slotted Lap Joint detail
2 of the Branches could not fit into slots because of the geometry of adjacent Branches
Need to offset Branches, adjust the angle of slot so that they bypass each adjacent Branch
Sketch Detail

7 thoughts on “CNC joint skill builder… no glue just slip lock and load”

Leave a Reply

Your email address will not be published. Required fields are marked *